Where To Drain Water Softener

How to drain the brine tank on a water softener.

Where to drain water softener.

A post fill system will automatically refill its brine tank at the end of each regeneration cycle. One of the drain tubes connects to the control valve and is used to void the backwash water during the regeneration cycle. Water softeners are designed to prevent minerals from scaling on your pipes and fixtures but funnily enough they are subject to salt which is still a mineral scaling inside the tank and within the system s lines. Use a wet dry vacuum.

This is to prevent non potable water from flowing backwards possibly mixing and contaminating potable drinking water. By code water softeners must be emptied into a laundry sink floor drain sump hole or properly trapped special outlet preserving an air gap of at. Finally add the water softening salt to the brine tank. Thereby we need to differentiate between pre and post fill water softeners.

The other drain tube connects to the brine tank and serves as an overflow drain. It should be not less than two 50 lb bags. Both lines then run to the home drain but they should not be connected together. You will achieve the best results when the tank is at least a quarter full.

Rinse with clean water restore all accessories and reconnect the drain and water softener. 2 water softener problems salt bridges. According to most plumbing codes a water softener drain line must not be connected directly to the household waste system. Draining a brine tank is necessary for cleaning sanitizing and troubleshooting.

If you don t like the idea of scooping out all of that water by hand a wet dry vacuum also known as a shop vac can easily and conveniently suck out the water inside your water softener brine tank. Most water softeners require two drain tubes.